Pur Line HEATY EX2000 Manual De Usuario página 11

INSTALLATION
Before installing your appliance, you must disconnect the electrical supply at the circuit breaker.
1) Insert the lower post assembly (11) into the base assembly (16) and then fix it tightly by means of 4-M6X24
screw, and insert the clamp (12) into the lower post (11).
2) Join the Lower Post Assembly (11) and the Middle Post (9) together with 3-M5X6screw.
3) Join the Upper Post Assembly (7) and the Middle Post (9) together with 3-M5X6 screw.
4) Join the Heating Element Assembly (1) and the Upper Post Assembly (7) together, then fix them tightly by
rotating the Knob, and put the power cord supply into the clamp.
5) According to the request of use angle, Heating Element Assembly can adjust angle at 0º~45º. Having
selected the angle, tighten the screws.
OPERATION
The appliance is switched on by means of the pull switch (5). The slight vibration noticeable when the appliance
is switched on will stop after a few seconds.
- Position 0: Stop
- Position 1: 650W (normal power)
- Position 2: 1300W (intermediate power)
- Position 3: 2000W (full power)
EN
9