General Instructions - SystemAir KVB Manual De Instrucciones

GB
KVB / KVD / KPB / KPD / mVent / mVec
G
eneral instructions
the following instructions must be considered as an integral component of
this product, and the installer person must take care to abide by them, and
be sure that this manual is kept and its instructions respected for further
manipulations of the product.
the manufacturer, Systemair, stress the point of his request, that the product
must be installed by a qualified person.
Always remember that wrong installation might cause important troubles
or damages to people, animals or objets, in which case, Systemair would
not accept claims or responsibilities for such damages, if the instructions of
this manual are not respected.
Once the product is unwrapped, make sure that it is in good shape. If you
are not sure of it, please contact the supplier.
All packing elements, palettes, plastics, staples, etc, must be thrown to the
corresponding recycling binds, and in case of not possibility, to insure that
they are not leave at random, since these elements are a potential source
of danger, and always bearing in mind to harm as less as possible the natu-
ral environment.
When proceed for a cleaning or maintenance operation, the product must
be disconnected from the electric supply.
never block the inlet or outlet, and protect both from involuntary contact,
and do the same with the shaft(s), pulley(s), belt(s), and rest of turning/
moving components. Systemair has a wide range of protection articles for
these purposes, and you are invited to consult them in our catalogue
(www.systemair.com).
In case any damage or bad function of the product happens, do not try
direct repair or manipulation, and contact the supplier. the not compliance
of this rule means the loss of the product guarantee.
2