tuctuc YUPI 2.0 Manual De Instrucciones página 13

INSTRUCTIONS FOR ASSEMBLY AND USE
1. Opening the stroller (see F1)
To unfold the chassis, first release the auto-locking
device, then hold the stroller by the handlebar and
softly push the front part down, then press the
plastic pedal until you hear a "Click", the stroller is
now open.
2. Fitting the wheels (see F2)
To fit the front and rear wheels, insert each wheel
into its support until you hear a click from the
automatic button. Press the button and pull on
the wheels to remove from their position.
3. Fitting the canopy (see F3)
To fit and remove the canopy, align the hooks of
the canopy with the holes prepared for this purpose,
press until you hear a click. Press the tab and pull
on the canopy to remove it.
4. Fitting the bumper guard
To fit and remove the bumper guard, align it with
the pins with holes on the adaptors, slide and press
until you hear a "click", press both buttons to remove
the bumper guard from the adaptors.
5. Using the Brake (see F5)
To use the brake, press the brake pedal down and
the stroller will be immobilised. Raise the pedal
and the brake will be released.
6. Using the canopy (see F6)
To open the canopy, you must zip up the transversal
zip of the stroller. To remove it, unlock the side
supports and move the canopy backwards.
Do not carry objects weighing more than 500
grams, as this may affect the performance of the
canopy.
7. Use of the foot rest (see F7)
To lower the height of the foot rest, press both
levers and push the foot rest down, to raise it just
move the support upwards.
(see F4)
8. Using the back (see F8)
The back can be adjusted in three different
positions. To lower the back, just lift the lever
located behind the basket, the back will descend
automatically. To raise the back, push it upwards
from the centre until it reaches the desired angle
and it will automatically be locked in the correct
position.
9. Using the restraint system
To release the straps, press the central button and
pull the harnesses outwards. To fasten the belts,
insert the anchoring points into the central catch
until you hear a click, indicating that the belt is
secured.
10. Adjusting the harness
This chair has a restraint system adapted to the
baby's size, to adjust the strap to the correct length,
insert the strap into the loop best adapted to the
size of the baby.
11. Folding the stroller
Note: make sure the backrest is in the highest po-
sition before folding the buggy. Always remove
the rain cover, stow it in the basket, and fold the
canopy.
Lift up the central pedal on the rear cross-strut
and press the handle on the right side of the bug-
gy as shown in Figure A.
Important! Press the central button on the handle
to fold it. If you do not, an excessive amount of
pressure will be placed on the buggy's chassis and
it could be damaged.
Fold the buggy's chassis as shown in Figure B.
Make sure you lock it in the folded position using
the safety latch.
(see F9)
(see F10)
(see F11)
13