Taurus TANGER 600 Manual De Instrucciones página 11

ENGLISH
ELECTRIC RADIATOR
TANGER 600/900/1200/2000
DESCRIPTION
A1 Panel Control
B1 LCD screen
C1 Carry handle
D1 On switch
E1 Body
F1 Heat outlet
G1 Wall support
H1 Foot base
I1 Screws
Control panel and LCD screen
Screen symbols
1 Heating on
2 Power level
3 Temperature
4 "Open window" function
5 Comfort Mode
6 ECO Mode
7 Ioniser Function
8 Weekly programmin
Buttons
A On / Off
B Power button
C Weekly programming
D Temperature programmer
E Mode
F "+"
G "–"
H Ioniser function
USE AND CARE:
- Fully unroll the appliance's power cable before
each use.
- Do not use the appliance if the on/off switch
does not work.
- Do not use the appliance at an angle or turn it
over.
- Do not turn the appliance over while it is in use
or connected to the mains.
- Unplug the appliance from the mains when not
in use and before undertaking any cleaning
task.
- Store this appliance out of reach of children
and/or those with reduced physical, sensorial
or mental abilities or who are unfamiliar with
its use
- Do not put the appliance away if it is still hot.
- Keep the appliance in a dry, dust-free place,
out of direct sunlight.
- Never leave the appliance unattended while in
use.
- Never leave the appliance connected and un-
attended if is not in use. This saves energy and
prolongs the life of the appliance.
INSTALLATION
- Be sure to remove all packaging material from
inside the appliance.
- Do not remove the support feet of the appli-
ance.
- Do not remove the feet or castors of the appli-
ance.
- Ensure that the appliance is level with respect
to the floor.
- The appliance needs to be correctly ventilated
in order to operate correctly. Leave a gap of .
above, behind and at both sides of the appli-
ance. (Fig. 3)
- The plug must be easily accessible so it can be
disconnected in an emergency.
- For greater efficiency, the appliance must be
installed in a location in which the ambient
temperature is between 12 to 32ºC.
ASSEMBLING THE WALL BRACKET:
- The appliance has a wall support to support
the product.
- Fix the wall support as you think appropriate,
using wall plugs, screws, adhesive...
- Taking into account the separation distances
mentioned above, place the wall support in the
required position and mark the drilling points
on the wall (Fig,1,.2,3).
- Make sure that the bracket is firmly fixed; it
should be able to support twice the weight of
the appliance.