Filling Fuel - Zibro R 421 E Instrucciones De Uso

ManUal
A
INSTALLING THE HEATER
B
1 Carefully remove your Zibro heater from the box and check the contents.
In addition to the heater you also need to have:
e a manual fuel pump
e a transportation cap
e these directions for use
C
Keep the box and the packaging materials (Fig. A) for storage and/or transportation.
2 Remove the other packaging materials:
e Remove the packaging material from the grill G. Lift the grill from the slot
(Fig. B) and pull it forward.
e Push the packing material on top of the combustion chamber D slightly
D
down and remove it (Fig. C). Remove the packaging materials from under
the combustion chamber as well (Fig. D).
e Put the combustion chamber back into its place. The combustion chamber
is positioned correctly when it can be smoothly moved a little to the left
and to the right by its handle E (Fig. E). Close the grill: Slightly lift it to
reposition it in its slot.
E
e Open the lid for removable tank H and remove the piece of cardboard.
3 Fill the removable tank as indicated in Section B.
4 Insert the batteries into their holder L at the back of the heater (Fig. F).
Ensure that the positive and negative poles match the + and - marks indicated
F on the battery housing.
5 The floor should be firm and completely level.
6
Your heater is now ready for use.
B

FILLING FUEL

G
Do not fill the removable tank in the living room, but in a more suitable place
(there can always be some spillage). Follow the procedure below:
1 Make sure that the heater is switched off.
2 Open the lid H and lift the removable tank I out of the heater (Fig. G).
Note: Some drops may leak from the tank. Put down the removable tank
(cap pointing upwards) and screw off the fuel cap.
e e e e e e
4
69