Memory Backup; Setting The Clock - Proline CR71 Manual De Instrucciones

OVERVIEW
1. Speaker
2. Alarm Set Button
3. Sleep Button
4. Function Selector (On/Off/Auto)
5. Snooze / Time Set Button
6. Clock Display
7. Volume Control / Alarm Mode
8. AM/FM Band Switch
9. Hour Set Button
10. Minute Set Button
11. Tuning Control
12. Frequency Scale
13. AC Power Cord
14. Battery Cover (at the bottom)
* Do not connect FM Antenna to external antenna.

MEMORY BACKUP

Install the battery
1. Open the Battery Cover located on the bottom of the product.
2. Connect one 9V battery (not included) to the battery clip inside the battery compartment
3. Replace the battery cover.
This battery will maintain the actual time and alarm time in its memory during a power
outage, but will not display it on the Clock Display. Normal display and functions will
resume when the power is restored. We recommend checking and/or replacing the battery
every one to three months. If the battery is weak, replace it immediately. We recommend
the use of a good quality battery for maximum performance.
Do not dispose of battery in a fire as this constitutes an explosion hazard.
SWITCHING ON
Place your clock radio on a flat surface. Plug the AC Power Cord into the wall socket.
Please note that unless the "Power Back-up" DC9V battery has been installed, the clock
display will flash if the electrical power has been interrupted. If this happens, you will need
to reset the time and the alarm setting.

SETTING THE CLOCK

Press and hold the SNOOZE/TIME SET button.
1.
2. Press the Hour button repeatedly until the correct hour setting is reached.
3. Keep holding down the
Downloaded from www.vandenborre.be
SNOOZE/TIME SET
EN-3
button and press the Minute button