Using The Rev Setting; Cleaning - Pembrook MA 501-17 Manual Del Usuario

Using the REV setting

Use the REV setting to put the cutters into reverse operating direction.
1. Move the slide switch
The cutters run in reverse and move the fed paper back out of the shredder.
2. Take the paper out of the shredder in order to continue with the shredding
process (see "paper jam" in the fault table).

Cleaning

NOTICE!
Risk of short circuit!
Water that has penetrated the housing may cause a short circuit.
− Disconnect the power plug before cleaning.
− Never submerge the paper shredder in water.
− Make sure that no water penetrates the housing.
NOTICE!
Risk of damage!
Improper handling of the paper shredder may result in damage
to the paper shredder.
− Do not use any aggressive cleaners, brushes with metal
or nylon bristles, sharp or metallic cleaning utensils such
as knives, metal sponges and the like. They could damage
the surfaces.
− Use a damp cloth to wipe off the paper shredder. Let all parts dry completely
afterwards.
The paper shredder is maintenance-free and the cutting
mechanism need not be treated with special oil.
5
to the REV position.
Cleaning
15