Installation Instructions; Características De Su Heladera Para Vinos; Tools You Will Need; For Your Safety - Silhouette DWC2121BLS Manual Del Usuario

Tabla de contenido

Publicidad

Installation Instructions - Intergrated Application
Tools You Will
Need
Safety Glasses

FOR YOUR SAFETY:

While performing
installations described in
this section, gloves, safety
glasses or goggles should
be worn.
Drill & Hole Saw set
Preparing the
• It is recommended that you do
not install the wine cooler into a
Enclosure
corner (i.e. directly beside a
wall). This is to allow the door(s)
to have a greater then 90° open-
ing swing. A limited door swing
Electrical Requirements:
will prevent the shelves from
sliding out as intended, and may
The appliance must be
lead to damaging the door gas-
connected to an individual
ket(s).
properly grounded electrical
outlet, protected by a 15 or
• The rough cabinet opening
20 ampere circuit breaker or
must be on a level floor area
time delay fuse.
and at least 24" deep* by 24"
wide. The opening should also
have a height of at least 34-1/2".
Fig C
1-1/2" dia. hole
*if electical outlet
is in adjacent
cabinetry
34-1/2"
From
Underside of
Countertop to
Floor
Electrical Access
*The listed depth requirment for the installation is assuming that the electrical outlet is located in the adja-
cent cabinetry or is flush mounted in the rear wall, not surface mounted in the enclosure.
8
Level
Gloves
Flashlight
Carpenters
Square
Measuring
Tape
• The electrical outlet may be
positioned from within either
side of the adjacent cabinetry, or
the rear of the shaded area (as
shown in Fig C.).
Important: If the electrical out-
let is surface mounted (not flush)
within the enclosure, the depth
requirment for the installation be
affected.
• If the electrical outlet is located
inside the adjacent cabinetry, cut
a 1-1/2" diameter hole to admit
the power cord.
24"
Min*
2"
Cabinets
Square
and
Plumb
6"
24"
Instrucciones de Operación
Características de su
Heladera para Vinos
2
3
6
1. Componentes Independientes:
6. Escape Frontal:
Separados para permitirle guardar diferentes
lación empotrada.
tipos de vinos.
7. Puertas de Vidrio Templado:
2. Controles Electrónicos Dobles:
Permite ver fácilmente el interior. Polarizadas
Para regular independientemente la temper-
para proteger contra la radiación UV.
atura de ambos compartimientos de la
8. Patas Niveladoras
heladera para vinos.
9. Luces Interiores (no se muestran):
3. Juntas Magnéticas de la Puesta:
Se encienden cuando se abre cualquiera de
Las juntas ajustadas mantienen todo el poder
las puertas.
de enfriamiento y los niveles de humedad.
10. Llave de Encendido para Luces
Interiores:
4. Estantes con Terminación de
mente las luces interiores con las puertas
Madera:
Se deslizan hacia fuera para
cerradas.
facilitar el acceso al vino.
5. Trabas con llave a prueba de niños.
29
1
5
4
7
10
8
Permite su insta-
Para encender/apagar manual-

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido