Required Components - Milltronics RBSS Manual De Instrucciones

Installation

Required Components

Installation requires the following components:
• one Return Belt Speed Sensor
• One 24 mm (1") diameter cross bar, cut to the appropriate length (see
Steps
on page 3) – customer supplied
• Two 24 mm (1") flat washers – customer supplied
Mounting
Location
The Return Belt Speed Sensor should be located near the scale assembly to simplify
wiring. The wheel should ride on the return belt, either just before or just after a return
belt idler.
belt
wheel
return belt
travel
Page 2
stringer
cable
RBSS – INSTRUCTION MANUAL
Installation
24mm (1") washers (customer
supplied) 3mm (1/8") from RBSS
24mm (1") diameter
cross bar (customer
supplied)
stringer
7ML19981GX61