Switching On/Off - Air-O-Swiss AOS W520 Instrucciones Para El Uso

Unpacking (1 – 3)
• Remove the Air Washer carefully from the packaging.
• Use the original packaging for storage if you do not use
the Air Washer the whole year.
• All packaging components consist of environmentally
friendly materials and can be disposed of with the
appropriate local waste management.
Positioning (4 – 7)
Check data regarding the power supply on the rating plate.
Place the Air Washer on the floor or on a flat, dry surface
in the room.
• The rating plate is located on the backside of the
appliance (4).
• Remember to ensure easy accessibility and sufficient
room for servicing and cleaning the Air Washer.
Filling with water (8 – 10)
Only fill the water tank with fresh, cold tap water.
Do not pressurize the water tank, e.g. by filling
it with carbonated mineral water. Do not add es-
sential oils or fragrances to the water; the plastic
material could possibly be discolored or dama-
ged. Close the screw cap completely to prevent
leakage from the water tank.
Putting into operation (11 – 15)
Connect the Air Washer to the mains (signal tone) and press
button A (12). The digital display comes on and shows the
current humidity. When the appliance is switched on, the
desired value is set to 55% and the output level to «High».
To switch off, press button A.
A) Switching on/off
Pressing button A switches the appliance on. Pressing it
again switches the appliance off. This button is also used
to reset the cleaning symbol. See chapter «M) Cleaning the
appliance».
B) Setting humidity level
The appliance is fitted with a hygrostat. This measures the
relative air humidity and automatically switches the appli-
ance off when the desired value is reached. When switching
the unit on, the desired value is preset to 55%.
The desired value can be adjusted in steps of 5% by
pressing button B. The word DESIRED appears on the
display (N). The setting for the relative humidity ranges
from a minimum of 30% to a maximum of 80% relative
humidity or «Co» continous mode. A relative humidity
of between 40 and 60% is recommended. After a few
seconds, the display automatically changes to show the
current value (CURRENT) (N). Upon reaching the desired
relative humidity, the unit automatically switches off
(display shows DESIRED and CURRENT) (N). If the desired
Operating W520
relative humidity falls, the appliance automatically switches
on again.
C) Changing the output level
The Air Washer can be operated on three output levels.
Press button C to select between output levels Low «L»,
Medium «M» und High «H». The chosen output level is
shown in the display by symbol H.
D) Timer
Using button D, the operation time can be set – adjustable
between 1 and 8 hours, or continuous operation (Co).
Symbol G shows the operating period that has been set
(1h/2h/3h/4h/5h/6h/7h/8h/Co). The display will automati-
cally show the current value after a few seconds. The timer
can additionally be switched on in any mode.
en
17