Einhell Global OF-G 1100E Manual De Instrucciones página 9

Anleitung OF-G 1100 E 12spr.
Release the clamping handle (12) again and
lower the cutter to perform the routing job.
When you are finished with your work, return the
machine to starting position.
The speed of the router depends on the material to
be cut, the feed rate and the cutter used.
G.) Routing direction
The direction of routing must always be opposite
to the cutter's direction of rotation. Otherwise
there is a risk of injury from back kick.
G
H.) Moulding and edge-cutting
It is also possible to use special cutters with a
guide ring for moulding (a) and edge-cutting (b)
jobs.
Fit the cutter.
Feed the machine carefully up to the workpiece.
Move the guide pin or ball race (c) of the cutter
along the workpiece, applying light pressure.
Important:
Depending on the material, deeper cuts should
be performed in several passes.
Hold the router with both hands on all cutting
jobs.
H
a
c
24.10.2001 10:50 Uhr
b
c
Seite 9
7. Maintenance
Keep the ventilation slits in the motor housing
clean and clear at all times. Clean out the slits
with dry compressed air so that no oil or
condensed water from the compressed air line
gets into the machine.
GB
9