Accessories; Troubleshooting - Arctic Cove MLT0180 Manual Del Operador

FILTER MAINTENANCE
See Figure 21, page 17.
Periodically check the filter at the end of the water tube for
debris and to make sure it is in good condition. Remove the
plastic filter cover and rinse or replace the filter, then snap
the cover back together.
DISCONNECTING THE WATER TUBE FROM
THE T-CONNECTOR
See Figure 22, page 17.
For maintenance, replacement, or cleaning, it may be
necessary to disconnect the water tube from the T-connector.
To order these accessories, call 1-877-297-8911.
 Brass Misting Nozzle (5pk) .................................................................................................................. Model No. MAC080
 Nozzle Cleaner .................................................................................................................................. Model No. MACC008
WARNING:
Current attachments and accessories available for use with this product are listed above. Do not use any attachments
or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not
recommended can result in serious personal injury.
PROBLEM
Leak at nozzle, threaded hole, or
connection
NOTE: ILLUSTRATIONS BEGIN ON PAGE 12 AFTER
FRENCH AND SPANISH LANGUAGE SECTIONS.
This product has a one-year Limited Warranty.
For Warranty details go to www.arcticcove.com
MAINTENANCE
 Remove the battery pack.
 Remove the blue ring from the T-connector.
 Push the collar toward the T-connector while pulling the
 To replace the tube, see Installing the Misting Hose
 When the water tube is secured in the T-connector, re-

ACCESSORIES

TROUBLESHOOTING

POSSIBLE CAUSE
Nozzles clogged or dirty.
Misting tube or water hose connected
improperly.
10 — English
water tube in the opposite direction to release the tube.
Assembly into the Hood in the Assembly section of this
manual.
place the blue ring.
SOLUTION
Clean nozzles.
Reconnect misting tube or water hose.