Nelson PRO 5500 Manual Del Usuario página 3

6. PART CIRCLE ADJUSTMENT
A. REMOVE CLICK-SET ® DISK
and manually turn sprinkler until nozzle points to
the center of the desired watering area.
B. PLACE CLICK-SET ® DISK IN POSITION
GRAY SIDE UP
Adjust collars to desired angle.
C. MEMORY RING PROTECTION
If sprinkler is manually turned past the set
pattern, the memory ring will pop temporarily out
of position while the sprinkler rotates around to
its original part circle pattern. If the memory ring
gets out of position while you are setting the
pattern, remove the disk and rotate the ring with
your fingers until the tab clicks into place.
7. CHECK WITH WATER ON
Check part circle patterns. Turn nozzle screw
clockwise to diffuse spray as needed. Make sure
top of nozzle screw is below surrounding plastic.
CAUTION: Turn water on SLOWLY to bleed air
during initial start-up.We recommend a velocity fill
rate of less than 2 feet per second.
8. REPLACE CAP
A. STANDARD INSTALLATION
Snap cap on and rotate mark away from nozzle
to lock.
B. LOCKING SCREW
Snap cap on and line up with nozzle. Turn screw
in through dimple on top of cap. Screw in until
top of screw is recessed into rubber.
6.
A & B
C. Memory Ring
Normal position Out of position
7.
8A.
8B.
3