Boost -COMBILED-20 Manual De Uso página 2

COMBINED LIGHT EFFECT ASTRO-STROBO-GOBO BEAM 3-IN-1
Safety Recommendations
Don't stare into the light beam
The unit complies with CE standards
For indoor use only
Minimum distance between the appliance and other objects
0.5m
• Please read the instructions carefully. They contain important information about the installation, operation and
maintenance. Keep this User Manual for future reference. If you sell the unit to another user, be sure that he
also receives this instruction booklet.
• The supplied mains adaptor must only be used with this product. Disconnect mains power before servicing.
• The unit is for indoor use only in a dry location.
• The unit must be installed in a location with adequate ventilation, at least 0.5m from adjacent surfaces. Be sure
that no ventilation slots are blocked.
• Make sure there are no inflammable materials close to the unit during operation.
• In the event of serious operating problem, stop using the unit immediately.
• Maximum ambient temperature (Ta) is 104° F (40°C). Do not operate the fixture at temperatures higher than
this.
• The light sources of the light effects are not replaceable. If a light source is faulty, the light effect must be dis-
carded.
• The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or
a similar qualified person.
• The product is for decorative purposes only and not suitable as a household room illumination.
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall
remain readily operable.
Installation
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to
avoid vibration and slipping while operating. Always ensure that the structure to which you are attaching the
unit is secure and able to support a weight of 10 times of the unit's weight. Also always use a safety cable that
can hold 12 times the weight of the unit when installing the fixture.
Operating Instructions:
1. Connect the supplied mains adaptor into a suitable outlet delivering a voltage of 100V-240V~50/60Hz.
2. When the unit is powered on, it will be running in program mode.
3. Press AUTO. The fixture will run in Auto Mode and the indicator will flash fast.
4. Press SOUND. The fixture will run in Sound Controlled Mode and the indicator will flash slowly.
Indicator Light
Remote Control
ON ON
OFF All OFF, Include Light off and Motor Rotate
Auto Auto Running the built-in program
Sound Sound control the built-in program
Paused and held the running state, and then press to continue running.
▶
+ In Auto Mode, to adjust the running speed.
In Sound Mode, to adjust the sound sensitive
2
INSTRUCTIONS FOR USE
Fast Flash
Slow Flash
Auto Mode
Sound Controlled Mode
EN