Perel Tools WLS552 Manual Del Usuario página 4

• Do not try and repair the log splitter yourself if lacking technical skills but leave service to a qualified technician.
• Check the log splitter, the oil level, and the protection boards before every operation. Do not operate the log
splitter if any of these fail.
• Start the log splitter at zero-load and make sure that the log splitter is in perfect working order before loading it.
• Never load two logs at a time or logs larger than the authorized size (see below). Remove all branches and make
sure the log does not contain nails and other debris. Do not load a log vertically onto the log splitter. The log
should be split along the direction of the vein. Never handle a log loaded onto the log splitter.
• Never overload or overcharge the log splitter. The log splitter may experience difficulties splitting extreme hard
woods. If this is the case, do not force the log splitter for more than 5 seconds.
• Never open or tamper with the log splitter or electric motor. Contact a qualified technician if the log splitter needs
servicing.
• Keep the power cable away from water and humidity at any time. Do not crimp the power cord and protect it
against damage. Have an authorised dealer replace it if necessary.
Read this manual before operating the
log splitter.
Always wear protective gloves.
No person or animal may be present
within a radius of 5 meters from the log
splitter apart from the operator.
Always pay attention to the movement of
the log pusher.
Recommended Log Size
The specified sizes are for reference only and depend
highly on the wood density and structure. The log
splitter may accept larger logs of softer wood. It is
important to remember that you may not force the log
splitter as oil may overheat and cause damage to the
log splitter.
WLS552
Disconnect from mains before starting
maintenance operation.
Wear protective goggles.
Do not dump used oil in the
environment. Dispose according to the
local legislation.
Never remove a log trapped in the
wedge with bare hands.
4
Wear safety footwear at all times.
Do not remove or tamper with the
safety devices on the log splitter.
Cutting or crushing danger: never touch
hazardous areas while log pusher is
moving.
Voltage as indicated on the rating plate.
PEREL