Emptying The Appliance; Thermal Cut-Out Reset - Olympia CM266 Manual De Instrucciones

UK
Operation
Power Indicator Light
Thermostat Dial
1. Connect the appliance to the power supply.
2. Fill the tank with water to a level between the
'MIN' and 'MAX' marks on the inside of the
tank.
Note: Olympia recommend that
fresh water be used each time
the appliance is used.
3. Switch the power switch to the On position [I].
The red power indicator light will turn on.
4. Turn the thermostat to the desired setting to
heat-up the appliance.
5. Once the appliance has heated the water, the
power indicator light turns Off.
6. Reduce the heat setting on the Thermostat to
maintain temperature.
WARNING: Do not allow the
water to drop below the 'MIN'
level during operation. Severe
damage to the heating element
could result.
4
CM266_ML_A5_v3_20190701.indb 4
Maintaining Water Levels
It is important to regularly check the water level in
the Bains Marie tank.
• Always keep the water level above the
'MIN' mark on the inside of the tank during
operation.
• Damage to the heating element can occur if
the tank boils dry and the element may have
to be replaced.
• This is not covered by the Olympia warranty.

Emptying the Appliance

Power switch
Use a suitable container to remove the water from
the appliance.

Thermal Cut-Out Reset

This appliance is fitted with a Thermal Cut-Out
safety feature. Should the temperature exceed safe
levels the appliance will automatically cut power.
The Safety Cut-out switch is located on side of the
appliance. To reset the appliance after a sufficient
cool-down period:
1. Unscrew the reset switch cover.
2. Press the small reset switch down until it clicks,
using a blunt pointed instrument.
3. The appliance is now reset and can be used as
normal.
Note: Always switch the
appliance off and allow the
water to cool before emptying.
WARNING: Ensure the appliance
has cooled down and is empty
before resetting the switch, as
it may need to be tipped slightly
to gain access to the switch.
2019/7/1 15:50