Twin Star 33WM0194 Manual De Instrucciones Adjunto página 6

3. Locate LH end Panel (E) and RH end Panel (F),
insert one Wood Dowel (CC) into each of the
pre-drilled holes. Use Bolts (AA) and Washers (BB)
through the pre-drilled holes in the mounting blocks.
HAND TIGHTEN ONLY.
Hardware Used
AA Bolt
BB
Washer
CC Wood Dowel
4. Insert one Wood Dowel (CC) into each of the
pre-drilled holes on the top edges of the Assembly
from step 3. Then locate Mantel/Top (G) and lay
fi nished side up on top of completed assembly.
From the inside, attach Mantel/Top (G) using Bolts
(AA) and Washers (BB) through the pre-drilled holes
in the mounting blocks.
HAND TIGHTEN ONLY.
Using Phillips head screwdriver tighten all Bolts
alternating top and bottom, left and right.
Hardware Used
AA Bolt
BB
Washer
CC Wood Dowel
5. Attach the Metal Grate (H) to the completed Front
panel assembly from step 4. Insert one Screw (DD)
into each of the pre-drilled holes.
Make sure the screws are seated into the pre-drilled
holes in the Metal Grate (H). Tighten all Screws (DD).
Hardware Used
DD
Screw
Fig. 3
x 10
F
x 10
x 4
Fig. 4
CC
x 7
x 7
x 4
Fig. 5
x 14
5
E
CC
G
BB
AA
DD
CC
H