Thrane & Thrane EXPLORER 300 Para Empezar página 5

a. Using the built-in compass of the EXPLORER 300 as reference, rotate
and tilt the antenna so that it points in the approximate direction of the
BGAN satellite.
b. Use the displayed signal strength and the pointing sound to find the
highest possible signal strength, while slowly rotating and tilting the
EXPLORER 300.
c. Press OK when you have obtained
the highest possible signal strength.
The EXPLORER 300 now starts to establish a connection to the BGAN
network.
The display shows the progress as follows:
• SEARCHING: The EXPLORER 300 searches for the network operator.
Note that the search procedure can be very short, so you may not see
this text.
• REGISTERING: When the network operator is found, the display shows
REGISTERING to show that the EXPLORER 300 is registering itself on the
network.
• READY: The EXPLORER 300 is registered on the network.
The display may show a different text, for example if an error has occurred.
For further information, refer to the User Manual.
GB