Installation Instruction - König Electronic ANT 108-KN Manual De Uso

The ANT 108-KN is a highly efficient amplified indoor AM/FM antenna with manual gain control.

Installation instruction:

1. Connect the FM (75Ohm) cable or AM (300Ohm) flat antenna wire to the audio system.
2. Plug power cord into the AC wall outlet.
FM
ANTENNA
Specifications:
Frequency range: 88 - 108MHz (FM) , 525 - 1705kHz (AM)
Gain: 25dB
Gain control: 0 ~ 25dB
S/NR: 3 dB
Power supply: 230V/AC 50Hz
Active power: < 3W (gain control active)
Static power: ~ 1.6W (gain control off)
Reception adjustment:
The antenna may be installed on top of a stereo audio receiver or in close proximity to the receiver
to get a better reception. Avoid installing the antenna near a CD player, computer or other digital
processing equipment because they may interfere with the FM reception. Fluorescent lights or other
electronic equipment may also interfere with the AM signal reception. If there is interference, either
turn off the interfering source or turn the antenna in a different direction.
This antenna can improve the signal receiving capability even with the gain control at the maximum
level. To amplify the signal turn the gain control knob until the receiver reaches its best reception.
Safety precautions:
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
from mains and other equipment if a problem should occur. Do not expose the product to water or
moisture.
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
General:
Designs and specifications are subject to change without notice.
ENGLISH
AM
ANTENNA
To reduce risk of electric shock, this product should ONLY be opened by
an authorized technician when service is required. Disconnect the product
2