Powerfix Profi Z31280 Instrucciones De Montaje página 15

The drill stand must be mounted on a
workbench or a stable, tilt-free table, to
ensure a safe work. Use the drill holes
the base plate .
6
§ assembly
Note: You need a 5 mm hexagon key (provided),
two open-ended spanners (10 mm & 14 mm) and
a slot screwdriver (1.2 x 8.0 mm) for assembly and
adjustment.
Connect the pillar
7
Then fix the slider
9
Mount the lever arm
(see Fig. B). Tighten the screws and nuts as
tight as possible.
Mount the vice onto the base plate. To do
13
this connect the screws with the guide slots
in the base plate through the two long slots
(see Fig. C).
Note: The vice can be positioned exactly by
moving the guide slots and long slots.
§ Mounting the work-piece
Hold the quick-release button
pull the locking device
goes (see Fig. D).
Place the work-piece into the vice
Press the quick-release button and push the
locking device with the clamping jaw
against the work-piece.
Fix the work-piece with a right turn (see Fig. E).
§ Clamping in and
adjusting the drill
Fit the drill with its clamping collar into the
drill holding fixture
(see Fig. F).
Insert a suitable drill bit into the chuck.
Unscrew bolt (see Fig. G).
12
Move the slider
9
on the pillar , until the drill nearly touches
7
the work-piece.
Retighten screw securely.
in
5
to the base plate .
6
on the pillar (see Fig. A).
onto the slider
2
pressed and
16
back as far as it
15
.
13
17
and tighten securely
3
with the clamped in drill
§ adjusting the drill depth
Loosen the block
slider (see Fig. H).
9
Loosen the locking screw
the left (see Fig. H).
Make sure that the bolt
doing this and slides down to the lowest
position.
Move the lever arm
the desired drill depth on the drill gauge with
indicator .
11
Fix the locking screw
right turn (see Fig. I).
§ adjusting the work piece
Loosen the fixing screws of the vice
4
Adjust the vice with the work piece by sliding
14
it into position.
Mark the exact position and punch a drilling
point on the work-piece. Retighten the vice
(see Fig. J).
§ Storage and care
Store the hexagon key in the fixture on the
slider.
Store the product in a dry place, out of the
reach of children.
Clean the product with a damp cloth.
Lightly grease the moving parts, rub the plain
metal parts with an oily cloth to protect them
from rust.
§ disposal
The packaging is made from
environmentally friendly materials,
which may be disposed through your
local recycling facilities.
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
product.
and slide it up to the
8
by turning it to
10
will be released
1
down and read off
2
and block with a
10 8
.
13
GB/MT 15