Cable Connectors - Ibiza COMBI-FX1 Manual De Instrucciones

Features
DMX controlled 4-in-1 light effect that will cover the dance floor with colorful patterns generated by the 4 built-in
light effects.
• 22 DMX channels
Red & green laser 130mW
•
• Strobe/Wash effect: 8 x 3W RGBW
ASTRO effect: 6 x 3W RGBWAV
•
• Derby effect: 4 x 3W RGBW
• Speed controls on all 4 units
Dimmer controls on the Strobe, Astro and Derby
•
• Operating modes: Auto, sound, DMX & remote controlled
• Remote control
Power supply .................................................................................................. 100-240Vac 50/60Hz
Consumption ................................................................................................................. 100W max.
Fuse ................................................................................................................ 3A/250V Ø5 x 20mm
DMX channels .............................................................................................................. 22 channels
Light source ..................................................................................................................18 x 3W LED
.................................................................................................... Laser red: 100mW, green: 30mW
Beam angle ................................................................................................................................. 15°
Dimensions ....................................................................................................... 400 x 270 x 160mm
Weight ................................................................................................................................. 3.032kg
Fixture Linking
You will need a serial data link to run light shows of one or more fixtures using a DMX-512 controller or to run
synchronized shows on two or more fixtures set to a master/slave operating mode. The combined number of
channels required by all fixtures on a serial data link determines the number of fixtures that the data link can
support.
Important: Fixtures on a serial/data link must be daisy chained in one single line. Maximum recommended serial
data link distance: 100 meters (1640 ft.) Maximum recommended number of fixtures on a serial data link: 32 fixtures

CABLE CONNECTORS

Cabling must have a male XLR connector on one end and a female XLR connector on the other end.
DMX connector configuration
Termination reduces signal errors. To avoid signal transmission problems and interference, it is always advisable to
connect a DMX signal terminator.
CAUTION
Do not allow contact between the common and the fixture's chassis ground. Grounding the common can cause a
ground loop, and your fixture may perform erratically. Test cables with an ohm meter to check correct polarity and
to make sure the pins are not grounded or shorted to the shield or each other.
Setting up a DMX Serial Data Link
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the controller.
2. Connect the end of the cable coming from the controller which will have a (female) 3 pin connector to the input
connector of the next fixture consisting of a (male) 3 pin connector.
©Copyright LOTRONIC 2017
COMMON
DMX +
INPUT
DMX-
COMBI-FX1
Resistance 120 ohm
1/ 4w between pin 2
(DMX-) and pin 3
(DMX+) of the last
fixture.
Page 3