Sears Kenmore 78079 Manual Del Propietário página 9

Installation
Figure 6. Modifying Mobile Home Window
1. Indoor sash (shown open)
2. Wood strip (1½" wide)
3. Window sill
4. Window frame
4
Installation Procedure
1. See Figure 7. Raise indoor sash and measure sash
width, including portion in window track. Cut window
sill gasket (Installation Kit Item A) to length of indoor
sash and apply to rear of indoor window sill. To
apply gasket, peel back about 2" of paper covering
gasket adhesive, and carefully press exposed
adhesive to one end of window sill. Slowly peel away
remaining paper cover from gasket adhesive, and
press gasket to sill as paper is pulled away.
If window has been modified for installed storm
window, apply gasket to wood strip added to sill.
For mobile home installation, apply gasket to
outdoor side of window frame bottom lip.
Figure 7. Applying Window Sill Gasket
1. Indoor sash
2. Indoor sill
3. Paper covering gasket adhesive
4. Gasket
4
1
2
3
1
2
3
2. See Figure 8. Thread adjusting foot (Item B) through
bottom of support bracket (Item C). Measure width
of window and mark center point of outside sill.
Figure 8. Support Bracket Assembly
1. Support bracket
2. Adjusting foot
3. See Figure 9. Center support bracket on outside sill,
1 3 / " from rear edge of indoor sill. Secure bracket to
16
outdoor sill with 2 hex-head screws (Item D).
Figure 9. Installing Support Bracket
3
1. 1 / " gap
16
2. Center of window
3. Hex-head screws
4. Bubble level
4
9
1
2
1
2
3