Troubleshooting - Kasanova MAS026823 Manual De Instrucciones

AROMA DIFFUSER
10
A. Drain side
B. Air outlet
PRECAUTIONS
Please check the below warnings to avoid malfunctions of the unit.
1. Do not fill over 130 ml of water into the tank at any time. The best water
temperature is 18°- 25°,it should not be over 40°.
2. Do not touch the ultrasonic vibration plate.
3. Clean regularly as per maintenance instructions to avoid malfunctions.
4. Always unplug from the power supply before maintenance.
5. After using, pour out the remaining water from the tank, and wipe the tank
with a clean and dry cloth.
6. Essential oils can stain, please wipe the oils away after using.
7. Keep the product away from heat sources, air conditioners or fans.
8. Do not tip the product when it is working because this may cause water to
enter the mechanisms and cause malfunctions.
9. Use pure water only, do not use mineral water or sparking water.
10. Keep it away from children and pets.
11. If smoke or burning smell is detected unplug it immediately.

TROUBLESHOOTING

Symptoms
Will not switch
on or switch
off early
No mist or
abnormal mist
IMPORTANT SAFETY INSTRUCTIONS
INSTRUCTIONS PERTAINING TO THE RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSONS
WARNING-When using electrical products, basic precautions
should always be followed, including the following:
• Read all the instructions before using the product.
• To reduce the risk of injury, a close supervision is necessary when a
product is used near children and/or pets.
• Do not put fingers or hands into the product while it is operating or
Possible Cause
Is there enough water in the tank?
Are the power cables
connected properly?
Not enough water?
Too much water?
Dirt on the ultrasonic plate?
Inner shell and outer shell are not
installed properly?
Dirt on the air suction port on the un-
derside of the base?
Solution
Add water to the tank.
Disconnect, check the cables and
re-connect them carefully.
Add water in the tank.
Water must never be filled over 130
ml (max) line.
Please refer to maintenance in-
structions, remove or reinstall them
correctly, so the vapours can be
released freely.
Clean the air suction port.
Reduced airflow will affect mist.