Orbegozo PWS 2046 Manual De Instrucciones página 14

PWS 2046
1. At start-up by pressing the ON/OFF function key, the fan will be put
to operation at low speed. After pressing ON/OFF key, you can choose
between any other functions.
2. After switching off the fan, the function which has been chosen last
will be saved in the memory. When switching on the next time, the
operation will be started with this function(with the exception of
TIMER).
3. Once the power plug is pulled out, the saved functions will be lost.
The fan will have to be re-started by reconnecting power plug to
outlet, pressing the ON/OFF function key, and then selecting desired
function.
Speed
1. You can choose between 3 constant speed settings: Low (LO), medium
(MID), High (HI), and then back to low.
2. The LED lamp on the control panel indicates the selected speed
setting.
Swing
By pressing the SWING key (in control panel) you can turn the SWING mode
(oscillation) on or off.
Timer (0.5h/1h/2h/4h)
1. You can choose different timer settings by pressing the TIMER key, to
set the length of time that the fan will operate before it turns off.
The time can be set by adding the indicated time intervals in
combination, up to 7 ½ hours.
2. The LED lamps on the control panel indicate the selected time setting.
3. To turn timer off, continue to press TIMER key until all timer LED
lamps are off. An alternate method is to turn fan off and then on
again.
REMOTE CONTROL
1. Remote control: Open the battery compartment and insert two AAA dry-
cell batteries. Use leak-proof alkaline batteries, if available.
2. Connect the power supply plug to a power outlet. You can now operate
the apparatus by means of either the function keys on the switch box
or on the remote controller.
3. A change in the function is usually indicated by a beep.
14