Maintenance/Storage; Technical Specifications - Perel DDPH2 Manual Del Usuario

8. Disassembly
 To disassemble the lift, lower the cradle [20] as far as possible, and slide the extension arms all
the way in.
 Remove the crossbars [21] by pushing on the flat springs and separating the tapered plates.
 Unlock the tilt latch and lift the cradle about 8cm to release it from the vertical frame.
 Hook the retaining hook [15] over the telescopic parts [8][9].
 Rotate the lock [12] at the end of the slide bar [11] counter clockwise and lift the slide bar
[11].
 Turn the winch wheel [16] until the winch assembly [10] is tight to the vertical frame [7].
 Gently pull the vertical frame [7] up while holding the tripod down.
 Press and hold the ring of the yoke [4] down while folding the two outer legs [2], until the yoke
pin snaps into the locking hole near the caster.

9. Maintenance/storage

 Keep the brake drum [17] clean and dry at all times. Check the drag on a regular basis to
ensure proper functioning of the hoist.
 Occasionally oil the cable pulleys. To access the inner pulleys, winch the lift up as far as possible.
 Occasionally oil the bearings of the casters.
 When operation becomes less smooth, apply some household paraffin to the sliding surfaces.
 Always store the hoist in a clean and dry area protected from harsh conditions.
10.

Technical specifications

lift
height
load weight (max.)
load dimensions (max.)
Weight
Use this device with original accessories only. Velleman nv cannot be held responsible in
the event of damage or injury resulted from (incorrect) use of this device.
For more info concerning this product, please visit our website www.perel.be.
The information in this manual is subject to change without prior notice.
00 (11/12/2012)
max.
min.
loading
DDPH2
3.35m (11 ft)
1.22m (4 ft)
0.86m (34 in)
68kg (150lbs)
4.88 x 1.22m (16 x 4 ft)
± 48kg
6