How Does The Easytouch Panel 10 Work; Installation (Factory Settings) - Marmitek Easy Touch Panel 10 Manual De Instrucciones

Marmitek products are manufactured with great care and are of the highest quality. Please read this manual carefully
and follow the instructions to ensure you make the most of the opportunities offered by this product.

2. HOW DOES THE EASYTOUCH PANEL 10 WORK?

The way the EasyTouch Panel 10 works can be compared to an X-10 remote control. With this product, however, instead
of the fixed keys on a remote control, you can easily choose and define the position, size and role of each button yourself.
The EasyTouch Panel 10 wirelessly sends the Marmitek X-10 commands (RF) to your Marmitek X-10 transceiver, which
then places this on the power line. The installed Marmitek X-10 modules receive these commands and switch on or dim
the connected lights and appliances.

3. INSTALLATION (FACTORY SETTINGS)

Remove the lip in the middle of the back of the panel, by the battery holder by pulling it, so that the EasyTouch Panel 10
can be connected to a power source. The factory settings are now immediately active and you can test the functions.
Ensure that you have placed the Marmitek X-10 transceiver within the range of the control panel and that this is set
to the house code(s) to be used. This ensures that the RF signals from the EasyTouch Panel are converted into X-10
signals and are put onto the powerline. If you use a TM13 as transceiver, this will transfer all house codes if it is set
to house code P.
Memory (factory settings)
The EasyTouch Panel 10 has a built in memory for 2 configurations (MEMORY 1 and MEMORY 2). The factory settings
are saved in configuration 1. Configuration 2 is empty. You can programme both configurations 1 and 2 as you wish (see
Chapter 4. PERSONALISING YOUR EASYTOUCH PANEL 10).
Operating (factory settings)
The following diagram shows the commands that are pre-programmed as factory settings in EasyTouch Panel 10's
MEMORY 1:
If you press on the first button, then address A1 ON will be sent. The appliances and/or lights that are at the address (A1)
will, therefore, go ON. And so on.
You can use the BRIGHT and DIM buttons to brighten or dim the light that you last operated.
Note: this only applies if a light (module) is installed at this address.
3
Easy Touch Panel 10™