Framing; Installing The Appliance Into Existing Fireplace - Napoleon NEFP24HT-HD Manual De Instalación Y Funcionamiento

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4.5

framing

4.5.1 installing the appliance into existing fireplace

note:
This appliance is equipped with nylon pads located on the bottom 4 corners. To prevent damaging the base
of the mantel or wood floor, carefully lift the appliance into the mantel or fireplace opening while avoiding
contact with the front edge of the mantel base or wood floor.
1. With two people, lift the appliance up and insert it into the opening, keeping a 3/8" (9.5mm) space between
the appliance and floor base to prevent scratching the floor surface. Do not push or slide the bottom of the
appliance or the floor base, see Figure 1.
2. Set the appliance down and into place, see Figure 2.
3. If the appliance does not sit flat on the floor or mantel base, apply a shim (not supplied) under the nylon pads
and adjust until level.
Fig. 1
STEP 1: LIFT
ÉTAPES 1: SOULEVER
APPLIANCE
APPAREIL
!
1/4"
note:
For fireplace opening or mantel opening dimension requirements, see "installing the appliance into the wall"
section.
MANTEL
TABLETTE
STEP 1: LIFT
ÉTAPES 1: SOULEVER
STEP 2: INSERT
ÉTAPES 2: INSÉREZ
APPLIANCE
APPAREIL
DO NOT SLIDE APPLIANCE
!
NE GLISSEZ PAS L'APPAREIL
MANTEL
TABLETTE
APPLIANCE
STEP 1: LIFT
ÉTAPES 1: SOULEVER
APPLIANCE
APPAREIL
1/4"
Fig. 2
MANTEL
TABLETTE
STEP 2: INSERT
ÉTAPES 2: INSÉREZ
DO NOT SLIDE APPLIANCE
!
!
NE GLISSEZ PAS L'APPAREIL
1/4"
MANTEL
TABLETTE
APPLIANCE
APPAREIL
STEP 3: SET
APPLIANCE
ÉTAPES 3: RÉGLÉ
APPAREIL
installation
STEP 2: INSERT
ÉTAPES 2: INSÉREZ
DO NOT SLIDE APPLIANCE
!
!
NE GLISSEZ PAS L'APPAREIL
MANTEL
TABLETTE
APPLIANCE
APPAREIL
STEP 3: SET
APPLIANCE
ÉTAPES 3: RÉGLÉ
APPAREIL
W415-1755 / 05.03.17
EN
13

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido