Selecting The Channel - Marmitek Megaview70 Manual De Instrucciones

5. SELECTING THE CHANNEL

The added Audio/Video-signal (of for instance a DVD-player or AV-camera) is converted into
a normal TV-channel.
With the MegaView70 you can actually choose every free channel. It is important to choose
a free channel, which is not yet in use by an existing TV-channel. Which channels are free
depends on the incoming antenna signal. For this, consult the channel chart provided by your
cable company, or if you have your own antenna, the channel overview in your TV-guide.
1. Connect the power adapter to the modulator and plug this in the socket.
2. Take your channel chart and look for two free adjacent channels. Then you choose the
higher of these two channels. Example: when channel 37 and 38 are free, you should
choose channel 38. With three free adjacent channels, you should choose the middle one.
3. Press the Mode key a few times until you see 'CH' appear on the display. Then 'CH' will
disappear again and a number will appear. Use the
modulator to select the chosen channel. The illuminated digital display on top of the panel
shows this channel.
4. Now switch on the desired A/V device (DVD, VCR, satellite receiver, PC, camera, etc.).
5. Turn on the TV, and find the selected channel. How to do this can be read in the manual
of your TV. If you cannot select channels on your TV set, but only frequencies, you can
look this up in the enclosed table in the back of this manual. This set channel now shows
the connected A/V device and from now on you can watch this on the channel you
selected.
6. Now check if there is no interference on the TV-channels close by. If there is, you need to
find two (or if possible three) other free channels and set the modulator to that one.
If you have multiple TV sets in your home (connected to the same antenna network), then
you can watch this signal on the other TV sets as well. However first you need to set the right
channel on every TV.
Megaview70™
and the keys on top of the
7