tuctuc BED RAIL NATURAL BEIGE Manual De Instrucciones página 27

HOW TO ASSEMBLE THE FRAME
1.- Remove the threaded pin from the rail; place structure G1 at an angle of 90º and
then replace the pin by putting the screw into the grommet and tightening using a
screwdriver. Repeat for G2.
2.- Attach tube C1 to C2 and click the pin into place. Push the single tube through
the hole in the cloth. Then connect the pipe to G1 and G2.
3.- Attach tube A1 to A2 and click the pin into place. Push the single tube through
the hole in the cloth. Then connect the pipe to G1 and G2.
4.- Place the rear clamping pipes B1 & B2 in position. Clamp together using their
threaded pin. Once joined together, connect the pipe to G1 and G2. The rail is now
ready to be attached to the bed.
A1
A1
G1
L
A2
A2
G2
A1
B1 B2
C1 C2
A2
27