Publicidad
Idiomas disponibles
Idiomas disponibles
PCE 5000
- Do not let cord hang over edge of table or
counter, or touch hot surfaces.
- Do not place on or near a hot gas or
electric burner, or in a heated oven.
- Do not clean with metal scouring pads.
Pieces
can
electrical parts, creating a shock hazard.
FIRST USE
Before using the product the first time, place it on a flat, dry and heat
resistant surface. Then, switch it on and let it work from 3 to 5 minutes with
the temperature controller in highest level, without putting anything on it.
This allows the special pre-use protective coating to evaporate. A bit of smoke
and smell is normal.
USING THE HOT PLATE
1. Set the glass-ceramic hob on a flat, dry heat resistant surface.
2. Turn temperature control dial to "0", the lowest position.
3. Plug cord into the outlet.
4. Turn control dial from "0" to any selected setting (being "1" minimum one
and "5", maximum one).
5. Heating Element will begin to heat immediately. DO NOT touch while in use,
the surfaces will become hot.
6. The light indicates that the plate is getting warm. Once it reaches the
selected temperature, the light turns off again.
7. When not in use, set the temperature controller in the lowest level, unplug
the cord from the wall outlet and allow until it gets cold.
Caution: DO NOT use pans that are unstable and easily tipped. Use flat-bottom
pans to ensure full contact with the heating plate for maximum heat efficiency.
For long-life performance, avoid dropping any items on the heating plate.
CLEANING AND MAINTENANCE
•
Always unplug unit and allow cooling before cleaning.
•
Never immerse in water.
•
Clean HEATING PLATE with a soft, damp cloth or a non-abrasive cleaner. Wipe
dry.
Disposal of old electrical appliances.
The European directive 2002/96/EC on Waste Electrical and Electronic Equipment
(WEEE), requires that old household electrical appliances must not be disposed
of in the normal unsorted municipal waste stream. Old appliances must be
break
off
the
pad
and
touch
10
Publicidad
