Force PT100942 Manual De Operador página 9

Machining method
Sanding
1. Materials:Wood,paint,metal,stone.
2. Typical application:
a) Sanding small areas,particularly in
corners,along edges and in areas
which are difficult to access.
b) Sanding down and stripping window
frames,furniture,railings,etc.
c) Sanding rust off vehicles.
d) Also random orbit,belt or
orbital sander for sanding
doors,gates,boats,wooden
floors,wooden stairs,etc.
3. Operating tips:
a) When sanding,move the power
tool continuously and applylight
pressure.
b) Work with the sanding pad flat on
the material;do not work with just the
point.
c) Do not apply excessive pressure;this
will not increase the cutting
performance,but will simply wear out
the sanding pad quicher.
d) Select a high vibration frequency,the
power tool is adjustable.
Sawing with the saw blade
1. Typical application: wood, plastics,
sheet metal.
2. Select high oscillation frequency.
3. The saw blade lasts longer if the wear
is distributed evenly. To ensure an even
distribution, loosen the saw blade, turn it
round a little and then tighten again firmly.
OPERATION
Sawing with the E-Cut saw blade
WARNING!
The sawing teeth are very sharp.
Do not touch during mounting
and application.Before sawing
make sure that no live cables will
be damaged. The workpiece must
be inserted firmly or clamped tightly
before it is processed.
1. Before sawing make sure that no live
cables will be damaged.
2. The workpiece must be inserted
firmly or clamped tightly before it is
processed.
3. Typical application: wood, plaster
board and soft plastics. Not suitable for
metal (e. g. nails) and stone.
4. Only clamp the E-Cut saw blade and
saw in a straight position. For fixation
use a tightening screw with a large disc.
Carefully remove the protective coating.
5. Always set the E-Cut saw blade
straight (at 90°) and guide it in the gap
without tilting. Always guide the E-Cut
saw blade along the cutting line without
exerting any pressure.
6. When plunging and sawing with
a slight pendulum motion, make
sure that sufficient chip removal is
provided for.
7. Keep a certain distance away from
hard metals (stone/metal) (approx. 3
mm), since there is increased danger
of the outer saw teeth breaking off.
Scraping
1. Typical application:
With rigid scraper
a) Removing damaged coatings,e.g.pai
nt,adhesives,underseal.
b) Removing carpet adhesive
residue(e.g.on stairs or other small
to mediumsized areas).
2. With flexible scraper
a) Light scraping work.
b) Removing stickers from glass
surfaces.
c) Removing old silicone filler
!
9