General Operation; Language Setting; Programming Mode; Operating Range - Omni International Bead Ruptor 12 Manual Del Usuario

1.
2.
3.
4.
5.
1. Program Number
2. Speed
3. Cycle Time
4. Navigation Buttons
5. Parameters Adjustment Buttons

Language Setting

Turn unit off. Press and hold
to select.
Choose from French, English, German, Italian, or Spanish.

Programming Mode

UP and DOWN - navigate through menu.
LEFT and RIGHT - adjust the parameters.
PARAMETER
S
Speed / Energy
T
Time
C
Number of Cycles
D
Dwell/Pause between Runs
- When the settings are entered press up
- Press "Run" to start.
- At the end of the program "DONE" will be displayed Followed by "REMOVE SAMPLES".
- If run is stopped system status will read "PROGRAM PAUSED".
- Pause or Stop a run anytime by pressing the "STOP" button.
- Press "STOP" again to cancel current run.

General Operation

20 o C
PROG 01
S =4.50 C=02
T=0:10 D=0:10
READY
6. Processing Chamber Temperature
7. Number of Cycles
8. Time interval or Dwell between each cycle
9. Run Button
10. Stop Button
while powering on unit.

OPERATING RANGE

From 0.8 m/s to 6 m/s
From 0:01 to 9:59 in increments of 1
second
1 to 10
0:00 to 9:59
or down to return to the program option.
6.
7.
8.
9.
10.