Product Care - Wagan Tech 2288 Manual De Usuario

12V Roadside Impact Wrench
• Insert the 12V power plug into the vehicle's power socket.
• Attach an appropriately sized socket to the 1/2" square drive anvil.
• Place the socket onto the lug nut and press the side of the switch with "L"
mark to start loosening the lug nuts.
• The motor starts and after a short warm-up time, the impact wrench gives a
pulse to the socket.
• Repeat for remaining lug nuts until they are loose.
Tighten Lug Nuts
• Put the wheel into position and hand-tighten the lug nuts prior to tightening
with the wrench. This helps avoid cross threading the lug nut.
• Press the side of the switch with "T" mark to start tightening the lug nuts.
• The lug nut will be tight enough when 4-5 clicks are heard. DO NOT over
tighten.
• Tighten the nuts in a star pattern.
• IMPORTANT: After tightening with the wrench, it is important to check the
specified torque by using a torque wrench. Consult your vehicle's manual
for recommended torque specifications.

PRODUCT CARE

• Handle the tool and accessories with care and keep them clean to ensure a
long service life.
• Do not make any modifications to the tool. Repairs to the tool or power cord
should be carried out by an authorized service technician.
• Disconnect the plug from the cigarette lighter before cleaning parts of the
tool, or if there is a problem with the tool.
• Do not use caustic, abrasive or solvent-based products for cleaning.
• Use a soft, dry cloth to wipe the tool clean.
5
by Wagan Tech
™
www.wagan.com
®