Connecting An External Unit; Maintenance - Aiwa XP-MP3 Instrucciones De Manejo

CONNECTING AN
EXTERNAL UNIT
Use a commercially available connection
cord which has a 3.5 ø stereo mini-plug at
one end and two phono plugs at the other
end.
Connect the stereo mini-plug to the
\/LINE OUT jack of the unit and connect the
phono plugs to the analog input terminals of
the external unit.
Note
• Turn off the power of both units before
connection.
• DO NOT connect to the PHONO inputs of
an amplifier (with a built-in phonoequalizer-
amplifier).
• Adjust the volume and DSL on this unit.
22
ENGLISH
R L
LINE IN
CD IN
AUX

MAINTENANCE

To clean the lens
If the lens becomes dirty, the player will skip
or not play. If this occurs, clean the lens in the
following manner.
To remove dust or dry particles, first use a
camera lens blower/brush a to blow a few
times to loosen particles, then gently brush
the lens b clean. Finish by blowing the lens
again.
To remove fingerprints, use a cotton swab
dipped in lens cleaning solution. Wipe gently
from the center to the edge. Lens cleaning
solution is commercially available.
Note
Take care not to get too much solution on the
swab, which could flow into the unit and
cause damage.
Pressing too strongly with the swab could
scratch or break the lens.