Operation; Maintenance; Important Information Concerning; The Environmentally Compatible - Vortice THERMOLOGIKA Manual De Instrucciones

ENGLISH
switch of suitable capacity, you are recommended to:
a. set the operating power with the cord switch;
b. remove the cord;
c. install the appliance on the relevant wall and
connect it electrically.
WARNING: It must be care of the installer selecting the
correct ratings of the Remote control switch or Relay
according to the number of the connected units.
Thermologika is now ready for use.

Operation

Pull on the pull-cord at the right of the appliance to
switch Thermologika on. This switch also selects the
heating power as follows:
Position "0": OFF
Position "1": 600 W
Position "2": 1,200 W
Position "3": 1,800 W
The status of the appliance and the current power
setting are shown in the window over the switch.
NB
When Thermologika is switched on, a slight buzzing is
sometimes produced by the quartz lamps. This is
normal and disappears after a few seconds. This in no
way affects the duration or performance of the
appliance.

Maintenance

Thermologika does
maintenance. Whenever necessary, wipe off any dust
from the outside with a soft dry cloth. Slightly damp the
cloth with water and neutral detergent to remove
stubborn dirt. Take special care under these
circumstances to avoid all contact with the quartz
lamps.
NB
Disconnect the appliance from the mains supply before
performing any maintenance.
not require any special

Important information concerning

the environmentally compatible

disposal

IN CERTAIN EUROPEAN UNION COUNTRIES THIS
PRODUCT DOES
REQUIREMENTS OF THE NATIONAL LAWS
IMPLEMENTING DIRECTIVE WEEE, AND IN
THESE COUNTRIES THE PRODUCT IS NOT
SUBJECT TO SEPARATE DISPOSAL OPERATIONS
AT THE END OF ITS WORKING LIFE.
This product conforms to EU Directive EU
2012/19/EC.
This appliance bears the symbol
of the barred waste bin. This
indicates that, at the end of its
useful life, it must not be disposed
of as domestic waste, but must be
taken to a collection centre for
waste electrical and electronic
equipment, or returned to a
retailer on purchase
replacement.
It is the user's responsibility to dispose of this
appliance through the appropriate channels at the end
of its useful life. Failure to do so may incur the
penalties established by laws governing waste
disposal.
Proper differential collection, and the subsequent
recycling, processing and environmentally compatible
disposal of waste equipment avoids unnecessary
damage to the environment and possible related
health risks, and also promotes recycling of the
materials used in the appliance.
For further information on waste collection and
disposal, contact your local waste disposal service, or
the shop from which you purchased the appliance.
Manufacturers and importers fulfil their responsibilities
for recycling, processing and environmentally
compatible disposal either directly or by participating
in collective systems.
NOT FALL WITHIN
of a
THE