Troubleshooting - Core Troy-Bilt TB4400 Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PROBLEM
THE BATTERY WILL NOT CHARGE
The battery charger is not plugged in
The battery is not fully inserted into the battery charger
The battery and/or charger are too hot or too cold
The battery and/or battery charger are no longer functional
THE BATTERY DIES QUICKLY
The battery is not fully charged
The battery and/or battery charger are no longer functional
THE MOTOR WILL NOT RUN
The battery lacks sufficient charge
The battery is not installed correctly
THE MOTOR STOPS WHILE IN USE
Device protection systems have engaged
THE MOTOR RUNS, BUT THE BLADES WILL NOT MOVE
The blades are jammed by debris
The blades are damaged

TROUBLESHOOTING

If further assistance is required, contact an authorized service dealer.
SOLUTION
Plug the battery charger into a 120V 60hz AC source
Remove and then reinsert the battery into the battery charger
completely
Make sure the battery and charger are in an environment between
32° and 104° F (0° and 40° C). Allow time for the battery and/or
charger to warm up or cool down.
Refer to the Warranty section for replacement information
Charge the battery completely
Refer to the Warranty section for replacement information
Charge the battery completely
Remove and reinstall the battery
Remove and reinstall the battery
Stop the motor, wait for all moving parts to stop, remove the battery,
and allow the unit to cool. Carefully remove the debris
Have the unit repaired by an authorized service center
15

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Productos relacionados para Core Troy-Bilt TB4400

Este manual también es adecuado para:

Troy-bilt tb4400b

Tabla de contenido