Trevi IP 380 V1 Manual Del Usuario página 19

Installation/Power On/Off:
• To turn on the device, connect the power adapter supplied to the power socket DC (5)
of the IP 380 V1 and the other end to the wall outlet. It will turn on automatically and
the display will turn on.
• Connect one end of the HDMI cable to socket (4), connect the other end to the HDMI
socket of your TV.
• Turn on the TV and wait a few seconds for the device loads the operating system.
• Press the Power button (9) on the remote control to bring in sleep mode the device. In this
way the video signal will be turned off, but the system will remain activated. The display
will switch off. Press the Power button (9) on the remote control to wake the device.
• Press and hold the Power button (9) on the remote control to turn off in standby mode
the device, select Shutdown with the navigation keys (11) and confirm by pressing OK
(12). In this way the entire system is turned off. The display will switch off. Press the
Power button (9) on the remote control to the heaters device.
WARNING: The unit is factory set with video output on HDMI, if you want to use the
composite AV output (cable not included), first connect the unit to a TV via HDMI and then
from the menu "Settings"/"Advanced Settings"/"Display"/"Screen resolution", select the
video resolution to 480 or 576.
Bluetooth remote control pairing:
For the first time, you must pair your Bluetooth remote control supplied with the device.
Press and hold for 5 seconds the keys V- (14) and PG- (18). The red light on the remote
flashes to indicate successful pairing.
Regulation framework:
At first power you need to set some parameters such as language, the connection to the
network and regulation of the framework.
Adjust the image according to your TV; to adjust the picture, select "Setting"- "Display"-
"Screenposition". Select "Zoom out" to tighten, select "Zoom in" to enlarge.
19
IP 380 V1