Descargar Imprimir esta página

Bladez Toyz BTSW002 Instrucciones De Uso página 4

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 8
Contents included
Open the battery compartment and insert the
batteries.
Attach radio control drive unit to inflatable
body (adult assembly required)
Inflate /Deflate the inflatable body
Switch on
To synchronise the handset and drive unit:
1. Slide the ON/OFF switch on drive unit to select the desired mode.
2. Press and hold the forward button on the handset for 2-3 seconds.
3. Once the wheels begin to turn the handset and drive unit are fully
synchronized and ready to use.
This R/C drive unit has an electronic protection mode. It will shut
down automatically after approximately 15 minutes if it is left ON
without use. To reset, turn drive unit OFF (O) and ON (I) again.
Vehicle operation
Multi - player setup
Operate up to a maximum of 10 players at the same time.
Each player must be setup individually.
1. Ensure player 1 is setup and ready.
2. Wait 10 seconds.
3. Repeat steps A - E for each player consecutively.
N.B. DO NOT setup more than one player at the same time.
If you try to setup multiple players at the same time the product
may not operate correctly due to interference.
Repair
- Inflatable must be completely deflated before repairing
punctures.
- Cut out a suitable size patch, and ensure the corners are rounded
to avoid peeling.
- Ensure puncture area is clean, then press patch over the puncture
firmly.
- Once the puncture has been repaired, do not inflate for 20
minutes.
The vehicle does not work
• Position the switches on the transmitter and vehicle to "ON".
• Have the batteries/power packs been inserted correctly?
• Are the battery contacts bent or dirty?
• Are the batteries discharged or defective?
The vehicle does not work properly;
the range is too small!
• Is battery/accumulator power fading?
• Are any other remote control devices close by which might be
transmitting on the same frequency?
• Is interference being caused by metal railings or fences?
• Transmitter or power masts often cause the model vehicle to
behave in an uncontrolled manner.
• Are there walkie-talkies or CB radios in the vicinity that might
cause interference?
Contents include
1x Inflatable
1x 2.4GHz Drive Unit
1x 2.4GHz Handset
1x Instruction Manual
1x PVC Repair Patch.
4
GB
Features
• Radio control vehicle
• 7 driving functions:
forward-left-right
backward-left-right, stop
• 2.4GHz
Precautions (Please retain!)
!
1. WARNING! Not suitable for children under three years.
Risk of choking due to small parts that may be swallowed!
Please keep this packaging information for any possible
correspondence. Subject to technical change and change of
color. Adult help is required to remove the securing devices.
2. Never lift the vehicle up while the wheels are still turning.
3. Keep fingers, hair and loose clothing clear from the motor or
wheels when the vehicle is switched to "ON".
4. To prevent accidental operation of the vehicle, batteries and
power packs must be removed from the toy when not in use.
5. To avoid accidental operation the transmitter must be
switched on before the vehicle. When switching off, always
switch the vehicle off and then the transmitter.
+
6. Only use the batteries specified! Put positive and negative
pole in the right place! Do not throw away used batteries in
-
the household garbage, but only give them to the collection
station or dispose of them at a special garbage depot.
Remove empty batteries from the toy. Non-rechargeable
batteries must not be recharged. Before charging remove
rechargeable batteries from the toy. Rechargeable batteries
must be charged under adult supervision only. Do not use
different types of batteries and do not mix new and used
batteries. Do not short-circuit connecter clips. Do not mix
old and new batteries. Do not mix alkaline, standard (carbon-
zinc), or rechargeable batteries.
7. To obtain the best result we recommend using only alkaline
batteries with the vehicle.
8. Wires are not to be inserted into socket-outlets
9. Do not over-inflate the body. Over-inflation can cause the
inflatable body to puncture.
10. Inflation and set up of product must be carried out by an
adult – keep away from children.
11. Do not sit on inflatable, it is not a ride-on toy.
12. Do not use a high pressure pump.
13. Never use any hard/ sharp objects to assist with inflation and
assembly of product.
Warning:
!
The manufacturer is not responsible for any radio or television
interference which might be caused by unauthorised
modifications to this equipment. Modifications of this nature
may invalidate the user's consumer rights.
Declaration of conformity:
in accordance with guidelines 1999/5/EC (R&TTE)
Bladez Toyz Ltd hereby declares that this item is in accordance with
the basic requirements and other relevant regulations of guideline
1999/5/EC.
The original declaration of compliance can be viewed on the Internet
at the following URL: http://www.bladeztoyz.co.uk/doc
Conforms to product safety standard ASTM F963-08 and EN71
regulatory requirements.
The meaning of the symbol on the product, packaging or
instructions. Electrical appliances are valuable products and
should not be thrown in the dustbin when they reach the end
of their serviceable life! Help us to protect the environment and
respect our resources by handing this appliance over at the
relevant recycling points. Questions related to this matter should
be directed to the organisation responsible for waste disposal or
retailer.
your specialist

Publicidad

loading