General Information; User Information; Safety Instructions - Hefter OL 420 Manual De Instrucciones

General information

The letter opener OL 420 is a machine constructed for the office environment.

User information

The letter opener OL 420 is a machine only destined for opening envelopes.
Any other use is not according to its specifications. The manufacturer/supplier is not
liable for any damage resulting of such un-allowed handling.
Use according to its specifications also includes the consideration of the operating
manual and the compliance with the maintenance instructions.
Any service, repair and maintenance must only be performed by skilled personnel of the
manufacturer or by authorized persons.
The letter opener Ol 420 is a table top machine and can, therefore, be placed onto an
existing table or a cabinet with a plane, scratch resistant and antislip surface. There do
not exist any special requirements with regard to the warranty of the stability during
operation.
Rated Operating Time max. 40 minutes.
The mains voltage must correspond to the indication on the type plate and the power.

Safety instructions

a. The machine must be used only in a technical good condition as well as in accordance
with the regulations, also considering the safety and risk according to the operating
instructions.
b. The operating instructions must be stored close to the machine and ready to hand.
c. The manufacturer cannot be held liable for any personal injury or material damage
occurred due to inadequate handling of the machine.
d. Do only use the power cord supplied or released by HEFTER Systemform. Take care
that the connexion cable is not damaged.
e. In case of unauthorized reconstruction or changes of the machine the manufacturer
does not undertake any liability.
For your own safety
a. Do not grip into the machine during the operation => Risk of injury!
b. Long hair, clothes such as ties and jewellery can be grasped by the rotary wheels. Use
of the machine under these circumstances is inadequate.
c. Connect the letter opener only to a plug with grounded contact.
d. Before any grip into the machine it must first be switched of and the power cord must be
disconnected.
e. Do not put any small/thin objects into the machine ⇒ Risk of electrocute!
f. Before you clean the OL 420 letter opener or remove it do not forget to disconnect the
power cord.
g. Have the maintenance and repair works only done by a HEFTER Systemform Service
Technician or by skilled personnel, authorized by HEFTER Systemform. In case of non
compliance the warranty claim will stop.
h. The machine must be protected against splash water.
Take care that no liquids get into the machine.
Warranty and return for repair
Please return the machine for a possible repair only in its original packing and freight
prepaid. Any packages freight unpaid cannot be accepted (please refer to the attached
warranty sheet).
3