Quarkpro light QP-3CH Manual De Usuario página 4

OPERATION
1, Select color mode:
Press "color select" button, the corresponding small LED light D2 is on, then you can
press: RED,ORANGE,YELLOW,GREEN,CYAN,BLUE,PURPLE,MAGENTA,WHITE to choose
your preferable color. You can also press R,G,B to choose Red, Green, or Blue.
2, Select built-in programs mode:
Press "PROG SELECT" button, the corresponding small LED light D3 is on, then you can
select the built-in programs via "PROG SELECT" slider, change the running speed (under
static color, this function is invalid) via "SPEED" slider and the frequency of flash (under
sound activated to adjust the sound sensitivity) via "flash/sensitivity" slider.
3, Auto run mode:
Press "AUTO" button, the corresponding small LED light D4 is on. Now you can change
the running speed via "SPEED" slider and the frequency of flash via "flash/sensitivity"
slider. But "PROG SELECT" slider is no use now.
4, SOUND ACTIVE mode:
Press "SOUND ACTIVE" button, the corresponding small LED light D5 is on. Then you can
change the sound active sensitivity via "flash/sensitivity" slider. "PROG SELECT" slider and
"SPEED" slider is no use now.
5, Any time when press "HOLD", the corresponding small LED light D1 is on, then you
can lock the current operation.
Under "HOLD"condition and turn off power, then turn on power again, the controller
keep the current scene.
6, Any time (not in lock condition) when press "BLACK OUT", the corresponding small
LED light D6 is on, the controller is without signal out.
2