Remote Control Functions - Promax 20.000 Instrucciones De Uso

-
-
-
Important note:
-
-
Additional Installation instructions:
Our specified outputs are always measured directly at the pump outlet (without
hose connection and accessories).
To achieve the highest possible pump output, keep the hose connections as
short as possible. Elbows, angles and other connecting elements should be
reduced to a minimum, as they lessen the pump output.
5.1 The hand transmitter – function control
Each time a button is depressed the red control LED is illuminated on the
manual transmitter.
5.2 Teaching a manual transmitter
-
-
After this sequence you can teach up to 10 transmitters (commands).
5.3 Delete transmitter (command) / reset to the original condition as
delivered
-
-

5.4 Remote control functions

5.5 change the stored values M0 and M1
-
-
-
-
Promax Exp.p65
GB Operating instructions
Lay the power cord in a protected manner to exclude the possibility of
damage.
Connect the pump to the electrical circuit.
In order to now operate the pump with the hand transmitter, you must teach
the receiver to respond to the transmission signal of the remote
control (see teaching a hand transmitter).
Never operate the pump without the filter basket. The filter basket/filter
protects the pump from coarse dirt that can lead to blockage of the pump.
Never operate the pump without water (dry run). The pump bearings will
be destroyed!
Briefly activate the learning key on the receiver (app. 1 second)
Activate a desired transmitting button for at least 3 seconds.
Activate the learn button on the receiver for at least 5 seconds.
Now you can reprogram the device (see Teaching a hand transmitter section 5.2)
-> Pump 1 Off (0) – On (I)
-> Pump 2 Off (0) – On (I)
-> call up memory 0 and 1
Reassign buffer 0 and 1
-> Pumps switched on
(+) larger water quantities
(+) smaller water quantities
Promax
Caution! The manual transmitter must have been previously taught
relative to the receiver.
Adjust the pumps and the displacement capacity to the desired value.
Briefly activate the learning key on the receiver (app. 1 second).
Press the M (0) or M (I) key for app. 3 seconds on the manual transmitter.
13
GB
learning key
08.04.2003, 14:06
13