General Precautions - Bose ControlSpace ESP-880 Guia De Instalacion

pro.Bose.com
12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus.
When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or when unused for long periods of time to prevent damage
to this product.
14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way such as power-
supply cord or plug is damaged; liquid has been spilled or objects have fallen into the apparatus; the apparatus has been exposed to rain
or moisture, does not operate normally, or has been dropped. Do not attempt to service this product yourself. Opening or removing covers may
expose you to dangerous voltages or other hazards. Please call Bose to be referred to an authorized service center near you.
15. To prevent risk of fire or electric shock, avoid overloading wall outlets, extension cords, or integral convenience receptacles.
16. Do not let objects or liquids enter the product – as they may touch dangerous voltage points or short-out parts that could result in a fire or electric
shock.
17. See product enclosure for safety related markings.
18. No naked flame sources, such as lighted candles, should be placed on the apparatus.
19. The mains plug is used to disconnect the device and it shall remain readily operable. To completely disconnect the power input, the mains
plug of the apparatus shall be disconnected from the mains.
20. The POWER indicator LED will illuminate green when the product has mains power. If power is applied and the LED is not illuminated, or if
the LED is red, please send the unit for service.
Bose Corporation hereby declares that this product is in compliance with the essential requirements and other relevant provisions of Directive
1999/5/EC and all other applicable EU directive requirements. The complete declaration of conformity can be found at: www.Bose.com/
compliance.
This product meets the immunity requirements for the E2 class EN55103-2 directive.
Inrush current at cold start, 230V: 9.47A
Inrush current after interruption for 5 sec, 230V: 41.16A
Information about products that generate electrical noise
If applicable, this equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communica-
tions. However, this is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, you are encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a different circuit than the one to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This product complies with the Canadian ICES-003 Class B specifications.

General precautions

CAUTION: Place the unit where it will be protected from heat and allow adequate ventilation. Place the unit away from direct heat sources, such as
heating vents and radiators. Make sure the air can circulate freely behind, beside and above the unit.
Do not allow the chassis to exceed the maximum operating temperature of 40˚C. Be aware of conditions in an enclosed rack that may increase the
temperature above room ambient conditions.
CAUTION: Be sure all the fine strands of the wire are twisted together and contained within the connector. If even one strand is loose and can touch the
adjacent terminal, a short circuit may occur.
The information furnished in this guide does not include all of the details of design, production, or variations of the equipment. Nor does it cover every
possible situation which may arise during installation, operation, or maintenance. If you need assistance beyond the scope of this installation guide,
please contact our Customer Service department.
English
Safety Information
Important
5