Network Settings And Infolink; Network Connection - Cable - Samsung 6 Serie Manual De Usuario

Network Settings and InfoLink
To access Samsung's Infolink network feature, you must make one of the connections on the following pages.

Network Connection - Cable

LAN Connection for a DHCP Environment
The procedures to set up the network using Dynamic Host Configuration Protocol (DHCP) are described below. Since an IP
address, subnet mask, gateway, and DNS are automatically allocated when DHCP is selected, you do not have to enter them
manually.
The Modem Port
on the Wall
Modem Cable

You can connect the LAN via a Sharer (Router).
The Modem Port
on the Wall
(ADSL/VDSL/Cable TV)
You can connect the LAN port and the TV directly depending on your network status.
The LAN Port
on the Wall
LAN Cable
The terminals (the position of the port and the type) of the external device may differ depending on the manufacturer.
➣
If the IP address allocation by the DHCP server has failed, turn the external modem off, turn it on again after at least 10
➣
seconds and then try again.
For the connections between the external modem and the Sharer (Router), refer to the owner's manual of the corresponding
➣
product.
You can connect the TV to the LAN directly without connecting it through a Sharer (Router)
➣
You cannot use a manual-connection-type ADSL modem because it does not support DHCP. You have to use an automatic-
➣
connection-type ADSL modem.
BN68-01532A-Eng.indb 89
External Modem
(ADSL/VDSL/Cable TV)
LAN
1
Cable
IP Sharer
LAN
Cable
External Modem
Modem Cable
TV Rear Panel
TV Rear Panel
TV Rear Panel
English - 8
1
Connect the [LAN] port
on the rear panel of the
TV and the external
modem with a LAN
Cable.
2
Connect the Modem
port on the wall and the
external modem with a
Modem Cable.
2008-04-18 오후 8:38:57