Ibiza Light WD300DMX Manual De Instrucciones página 3

Product Overview
Operating instructions
Manual frequency selection
Set one controller as a transmitter and the other as a receiver. They can work in pairs as long as they are set
to the same frequency. You can set several controllers as receivers and one as transmitter. They will work
together as long as they are set to the same frequency.
1. Mode selection:
Press the MODE button and TXXX for transmission
Press MODE again and RXXX is for reception.
2. Frequency band selection
In the frequency band selection, press UP to increase the working frequency or DOWN to decrease. The optional
frequencies range from 001 to 016. Press ENTER to confirm your choice.
Auto frequency selection
1) Mode selection:
Press the <Auto> button on the panel and select <t.-AU>for transmission, or press <Auto> and select <r.-AU> for
reception.
2) Auto frequency selection:
Set one controller as a transmitter and the other as a receiver. Press the <AUTO> button on the panel of the
transmitter until the signal of the receiver flashes, which means the frequencies of the two fixtures have matched
successfully. With memory save function, if the matching data is not removed, the two fixtures are matched to work
all the time.
3) Cancel matching:
©Copyright Lotronic 2016
1. Power input
2. 3-pin signal input
3. 3-pin signal output
4. 5-pin signal input
5. 5-pin signal output
6. Antenna
7. Control Panel
8. Auto button
9. M12 fixing hole
10. Safety eyebolt
Functions
The 16 working frequencies can be selected automatically or manually.
Frequency band
001
002
003
004
005
006
007
008
WD300DMX
Frequency Frequency band
2.433 009
2.4362 010
2.4394 011
2.4426 012
2.4458 013
2.449 014
2.4522 015
2.4554 016
Frequency
2.4586
2.4618
2.465
2.465
2.4714
2.4746
2.4778
2.481
3