Operating Conditions - Rothenberger Industrial 030955E Instrucciones De Uso

030955E_Anleitung
SAFETY INSTRUCTIONS
Read these instructions carefully and thoroughly before using the gas equipment.
Keep the instructions in a safe, easily accessible spot for later reference.
The product warranty expires when the tool is damaged due to improper use.
Assemble and disassemble the equipment as described by the manufacturer. Do not
assemble or disassemble gas tools other than described by the instructions.
Any modifications or structural changes to the equipment can be extremely hazardous. Do
not remove any parts or components. Do not replace any parts with parts that do not bear
the manufacturer's approval.
BEFORE CONNECTING THE VESSEL:
1. Use the described vessels/torch components only.
2. The use of inadequate or improper vessels/torch components can be exceptionally
hazardous.
3. Use manufacturer approved parts and accessories only.
4. Never connect your gas tool to a vessel without having previously read the vessel
instructions.
5. Ensure that all valves and connections are undamaged, sit properly and are tight.
6. Connect hose to the gas torch first and only then connect the hose to a vessel.
7. Carefully inspect any hoses before connecting.
8. Never use gas tools if any part or component shows signs of damage.
9. Connect hose to the respective vessels in a well-ventilated area, away from open fire or
flame, any source of possible ignition as well as any electric cooker. Do not assemble or
disassemble gas equipment near other people.
10. Always assemble equipment and accessories starting with the gas vessel.
11. Check all connections for leaks and ensure that each connection is gas-tight before using
the torch.
12. Never smoke while using gas tools and equipment.
13. Protect gas vessels against any rise in temperature. Protect hoses from scorching.
Change accessories whenever required.

OPERATING CONDITIONS

1. Set up tools and equipment in such a manner that they cannot tip or fall down.
2. To avoid the risk of LPG escaping from the vessels, always stand propane and oxygen
bottles upright and use gas cartridges in a slight oblique position only. Never lay flat or
turn upside down open propane and oxygen bottles or a gas cartridges when in use.
3. Never use the gas tool below ground level.
4. Never set up gas tools and equipment near sources of heat (heaters, furnaces, open fire
etc.).
5. Do not use in enclosed areas and provide adequate ventilation.
6. Operate away from combustible or oily materials. Always wear oil-free clothing.
7. Do not inhale soldering/welding fumes.
8. Shut off torch when not in use.
9. Never leave gas tools unattended when not in use. Any extinguishing of the flame can
allow gas to escape which poses an urgent hazard.
10. Keep this and all gas tools and equipment out of reach of children.
11. When using a new cartridge or propane bottle together with cold tools, a variation of the
flame can occur. This phenomenon tapers off within a short period of time.
12. Whenever using gas tools, even during short use, beware of the heat radiating from the
flame (glass, torch etc.). Negligence can lead to serious burns or injury.
13. Never modify your gas tool. Have repair and maintenance work carried out by competent
and qualified personnel.
06.10.2009 14:32 Uhr
6
Seite 6