Fonexion Ideus ITCAB200 Manual De Usuario página 24

ITCAB200
displays SET 6 LCD
Press SET to enter, LCD displays LCD 3, press ▲ or ▼ to
select among 1~5 levels.
Press SET key to confirm and exit.
FLASH AND PAUSE FUNCTION
When dial a number and the line is busy, press FLASH and REDIAL
key to dial it out again.
PAUSE FUNCTION
Press PAUSE key will give a 3.6s pause interval after press one or
more digit.
HOLD MUSIC FUNCTION
When talking over handset, press HOLD key to enter the hold mode
and the hold music is sent out. In hold mode:
Press HOLD key to release hold mode and continue to talk over
handset.
SETTING HANDSET VOLUME
Pick up the handset, press VOL key to adjust handset volume to
high or low.
SETTING RINGING VOLUME
There are two levels of ringing volume high or low for selection.
Slide the RING switch to HI or LO for selection.
SETTING THE LCD CONTRAST
In off-hook state, press BRI key continually to adjust the LCD
contrast, total 5 levels.
LCD BACKLIGHT FUNCTION
The backlight is turned on when receiving an incoming call, dialing,
pressing any key or in MUSIC HOLD mode. It will fade off if the
telephone is left idle for 6 seconds.
Note: If batteries are not loaded, then have no LCD back light
function.
WALL MOUNTABLE
It can be used on desktop, and it can also be used as wall-mounted.
Note: Please unplug telephone line when install or replace
batteries.
24
EN
USER GUIDE