Instruction Manual - Gardigo 60049 Manual De Instrucciones

Instruction manual
Art.-No. 60049
Dear client,
thank you for choosing one of our quality products. In the
following, we will explain the functions and operation of our
product. Please take the time to read through the instruc-
tions carefully. Please take some time to read through the
instructions carefully. Please note all the included safety and
operating instructions. Keep this manual safe and ensure
that you include it when passing on the product on to a third
party. If you have any questions or suggestions about this
product, please contact your supplier or our service team.
We would appreciate it if you would recommend us to others,
and we hope you enjoy using this unit.
1. General
The Animal Chaser Pro provides a convenient, effective and
humane way to deter cats, dogs, and even raccoons from your
garden, yard and lawn without harm. This product utilizes a
sophisticated PIR (passive infrared) detection system to mo-
nitor a large area up by up to an approximate distance of 23
ft. When an animal enters the area covered by the infrared
sensor, the Animal Chaser Pro produces an ultrasonic sound
at a frequency range from 18 kHz up to 60 kHz that is very
unpleasant to animals but virtually inaudible to the human
ear. In addition to the noise the unit emits, the Animal Chaser
Pro also emits an intense LED strobe light to further ward off
unwanted animals.
a. Speaker
b. LED strobe light
c. Passive Infre-red motion detector
(PIR)
d. Switch
e. Battery Compartment
Warning:
• Turn off the Animal Chaser Pro if your
pet is playing in the protected area!
• Do not immerse the unit in water or
any other liquid!
a
b
c
d
ON1 OFF ON2
e
• Do not modify or tamper the unit or its internal compo-
nents. Covering or painting over the front speaker grill can
damage the unit and cause it to malfunction.
• For best function, keep the PIR lens clear. Use a damp cloth
to wipe them. Do not use benzene, alcohol or paint thinner!
• Do not mount where it can fall and injure others!
Note: For outdoor use only. Your pets may not be deterred by
this product as they see your home as their home and ter-
ritory.
2. Battery Installation
1. Remove two screws on the
bottom of unit to access bat-
tery compartment
2. Insert 5 x "AA" alkaline or li-
thium batteries. Be sure to
follow the polarity diagram and insert the batteries cor-
rectly. Do not mix old and new batteries.
3. H ow to install
With Mounting Plate
1. Determine the location you want to place your Animal
Chaser Pro. Mounting locations are preferably at 5 to 8 ft in
height, in view of the protected area, out of reach of child-
ren and placed where it can not fall and injure
others.
2. Using a pencil, mark the center of where you
would like the screw to be placed and have a
drill bit a little smaller than the closed end of
the plastic anchor ready.
3. Using the drill bit, drill a hole through the
center of your mark and about as deep as the
an chor is long.
4. Using a hammer or rubber mallet, gently tap the anchor
until it is flush with the wall.
5. Insert the screw and slowly rotate it into the anchor leaving
about 1/8 or 1/4 of the screw out to hang the Solar Animal
Chaser.
Status: 05/17
6