Troubleshooting - amora apollo Manual De Instrucciones

Cleaning:
The device must be cleaned after each use. Before cleaning, disconnect
the power cord from the unit, remove the top cover of the device and
carefully pour out any remaining liquid, ensuring that you pour at the
opposite side to the Air Outlet (see diagram and names of parts to
recognise this).
Use the brush supplied or a soft cloth to carefully clean the inside of the
reservoir, especially around the ceramic disc. Do not use any cleaning
agents. If ordinary tap water is used in the device, natural mineral deposits
will gradually build up in the water tank. To avoid this, we recommend
using distilled or demineralised water.

Troubleshooting:

Should you have any problems with your device, please consult the table
below and action the suggested solutions provided, in accordance with the
instructions in this booklet.
Symptom
No Power
Mist, but no light
Light, but no mist
Keep the unit empty, clean and dry when not in use.
Possible cause
Power supply is not
connected
Light button is off
Mist button is off
Water level in tank is
too low
Water level in tank is
too high
Solution
Plug in the adapter and press the
Mist Button
Press light button (left button)
Press mist button (right button)
Refill the water tank
Remove some water until level is
below maximum level