Mounting Instructions; Cleaning And Maintenance; Technical Specifications - Perel CFAN0140S Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 9
5. Overview
Refer to the illustrations on page 2 of this manual.
1 front grille
2 fan blade locking nut
3 fan blade
4 rear grill locking nut
5 rear grille
6 control buttons
7 motor assembly

6. Mounting instructions

Refer to the illustrations on page 2 of this manual.
Note: Never use the fan without the safety grill in place.
Place the rear grille [5] on the motor assembly [7] (pins must fit in corresponding holes) and secure
it with the locking nut [4].
Place the fan blade [3] over de motor shaft (pins must rest in slots) and secure it with the locking
nut [2].
Place the front grille [1] on the rear grille [5], place the plastic grille clamp over the grille edges and
tighten it with the screw.
Tip: place the grille clamp over the rear grille and turn the screw 2 turns. Then gently push the front
grille in place and tighten the screw.
Place the upper cross bar [13] on the lower cross bar [14].
Mount the telescopic pole [11] on the cross bars with 4 screws.
Remove the locking knob [10] and slide the plastic cover [12] over the telescopic pole [11].Place
the locking knob [10] back
Place the fan assembly on top of the telescopic pole [11].
7. Operating instructions
Refer to the illustrations on page 2 of this manual.
Place the fan on a flat and sturdy surface. Make sure no objects (e.g. curtains) can be sucked into
the rear of the fan.
Insert the power plug [9] into the mains.
Adjust the tilt angle by pushing the grille.
To adjust the height, hold the fan assembly and release the locking knob [10]. Slide the fan
assembly to the desired height and secure with the locking knob [10].
Set the desired output speed via the control buttons [6]:
0...STOP
Push down the oscillation knob [8] to make the fan oscillate. Pull up the oscillation knob [8] to fix
the fans' position.
Always switch off the fan before moving it.
Switch off and unplug from the mains after use.

8. Cleaning and maintenance

Disconnect the device from the mains prior to maintenance activities.
Clean out the parts with a soft and dry cloth. Remove stains with a damp cloth and some mild soap.
Remove soap remnants with the damp cloth. Do not use abrasives.
Make sure no water or any other liquid enters the motor assembly [7] or the control buttons [6].
Keep the ventilation holes of the motor assembly [7] free from dust at all times.

9. Technical specifications

power
Ø fan
airflow
height
weight
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulted from (incorrect) use of this device. For more info
concerning this product and the latest version of this user manual, please visit our website
www.perel.eu. The information in this manual is subject to change without prior notice.
06.12.2010
CFAN0140S
1...LOW
50W
40cm
> 54m³/min.
135cm
3550g
4
8
oscillation knob
9
power cord
10 locking knob
11 telescopic pole
12 plastic cover
13 upper cross bar
14 lower cross bar
2...MEDIUM
power supply
oscillation arc
max. ambient temp
power cord length
3...HIGH
230Vac/50Hz
65°
50°C
1.5m
©Velleman nv

Publicidad

Tabla de contenido
loading

Tabla de contenido