Frontgate 42076 Manual De Instrucciones página 6

SET-UP
ASSEMBLY:
Before you begin assem bly please be sure all p arts and accesso ries have a rrived int act. Please use the
check list below to identify and order parts and accessories .
* Instruction manual * RCA cable * Slipmat * Platter
* 45 rpm adaptor * Headshell * AC cord * Counterweight
Note:
* Do not connect the AC power plug before assembly has been completed.
* Before turning the power on, make sure once again all the connections and power voltage settings are
correct.
Always turn off the power when connecting or disconnecting
* Read this manual carefully before using the unit. Be sure to store the manual in a safe place for future
reference.
* Attach a stylus cartridge to the headshell before assembling the turntable unit .
1. Removing from carton:
Carefully re move the main unit with the p acking material in tact from the box. Remove the p acking
material once the unit has been removed from the shipping carton. Be sure to locate all the accessories
located in the packing material.
2. 45 adaptor:
Locate and remove the 45-rpm adapter from the packing material and place it in the 45 adapter cut out
on the top of the main unit.
3. Turntable platter:
Remove the turnt able platter from th e p acking materi al and g ently insert the platter into the center
spindle on the base of the turntable unit.
4. Drive hub:
Pull the belt to the lower side of the turntable over the drive hub.
5. Slipmat:
Remove the black slipmat from the packaging and place it on the platter.
6. Headshell:
Insert the headshell into the front end of the tonearm assembly. While holding headshell firmly into the
front end of the tonearm assembly, turn the headshell locking nut counter-clockwise to firmly secure the
headshell to tonearm assembly.
7. Counterweight:
6